[an error occurred while processing this directive]
[an error occurred while processing this directive]
Thank you! Your e-mail has been sent. Return to the original page.
Metronix DIS 2 310/2 FB
Published Jun 13, 2011
The DIS-2 310/2 FB is a fully digital AC servo controller for three-phase synchronous motors with a supply voltage of 230Vac.
The DIS-2 is optimally suitable for the decentralised applications. It can be mounted directly to the terminal block of the motor or used as a stand alone unit in close proximity to the motor.
There are a number of operating modes to choose from: torque, speed or position control.
Programming and diagnosis are possible via an RS232 or CAN bus interface. The parameterisation program "DIS-2 ServoCommander™” can be used to quickly, easily and comfortably parameterise the DIS-2.
Features
- Compact design with one PCB
- Direct mounting on the motor
- 230Vac, 2A rated current, 6A peak current (1sec)
- High enclosure class up to IP67 when mounted
- Housing temperature up to +70°C
- Encoder evaluation: Resolver, digital and analogue hall sensors, SinCos encoder with HIPERFACE (incremental encoder feedback in preparation)
- Interfaces: RS 232, CAN bus, additional extension slot e.g. PROFIBUS
- Integrated CAN-Bus interface with DSP402
Technical Data
| DIS-2 320/2 | |
| Supply voltage | 1ph, 230Vac, +/- 10% |
| Rated current I-Rate | 2 Aeff |
| Maximum current IMax for 1 sec | 6 Aeff |
| Rated power P-Rate | 300 W |
| Clock frequency f-PWM | 10 kHz |
| Ambient temperature | 0° to +70 °C |
| System of protection | IP54, prepared for IP67 |
| Dimensions in mm (H x W x D) | 110 x 80 x 56 |
| Encoder evaluation | Resolver, digital and analogue hall sensors, incremental encoders, sincos encoder with HIPERFACE |
| Interfaces | RS 232, CAN bus, additional extension slot e.g. for PROFIBUS |